How To Use The Can Filling And Seaming Machine

Can filling and seaming machines have been used in many companies and enterprises. However, employees may not fully understand the can filling and seaming machine. In this article, the relevant knowledge of can filling and seaming machine will be introduced to a certain extent, including how to operate can filling and seaming machine. I hope that after reading this article, the information obtained is helpful to you.

 

l The operation steps of the can filling and seaming machine.

l Precautions for the use of the can filling and seaming machine.

l Can filling and seaming machine products provided by the company.

 

The operation steps of the can filling and seaming machine.

Turn on the power, turn on the power switch, the indicator light is on, set the thermostat to a predetermined temperature, and the green heating indicator light is on. When the upper heating plate reaches the predetermined temperature, the red constant temperature indicator light is on (when the can filling and seaming machine is working, the electric heating device is constantly alternating in the heating and heat preservation state, so the green and red indicator lights are also displayed alternately, which is a normal phenomenon).

Put the plastic cup into the lower mold slide, push the lower mold slide to a certain position by hand (if it is an automatic filling and seaming machine or automatic filling and seaming machine, after putting the plastic cup, the lower mold slide will automatically enter), and press it down The handle of the filling and seaming machine reaches the maximum stroke, keep the pressure for 1~2 seconds, then slowly raise the handle and push it to the original position.

Pull out the lower mold slide plate, take out the plastic cup, put in the last-sealed plastic cup, and perform another cycle.

 

Precautions for the use of the can filling and seaming machine.

1. It is not suitable for metal containers and metal caps, and can not be placed on a metal table to press the start button, otherwise the can filling and seaming machine will be damaged.

2. Before turning on the power, the induction aviation plug must be inserted and the screws must be tightened.

3. Use a single-phase three-wire power cord. For the safety of the operator, a single-phase three-wire power socket must be used. The ground of the workplace must be dry to maintain insulation.

4. During transportation, storage, and use, the can filling and seaming machine should not be hit, pressed, or damp.

 

Can filling and seaming machine products provided by the company.

Our company (WEIS) has a wide range of products. Mainly include plastic gloves, bottling machine, filling machine, filling and seaming machine, labeling machine, preform, palletizing system, etc. Among them, can filling and seaming machines include paint canning machines, jelly can filling and seaming machines, milk tea can filling and seaming machines, and fully automatic can filling and seaming machines. You can come to our company to check the can filling and seaming machine. If there is a can filling and seaming machine product that suits your needs, you can buy it. We will provide you with the best can filling and seaming machine products and services.

 

If you want to buy can filling and seaming machines and mold other products, you can consider our company (WEIS). Welcome to our company to buy can filling and seaming machine products, we will provide you with the best can filling and seaming machine products and services. We look forward to your visit. Finally, I wish you success at work, good health and a happy family.